Description

The methods presented in this SAE Recommended Practice apply to the controlled testing of low-temperature charge, air-cooled, heavy-duty diesel engines. This document encompasses the following main sections:

1. Definitions of pertinent parameters

2. Vehicle testing to determine typical values for these parameters

3. Description of the setup and operation of the test cell system

4. Validation testing of the test cell system

While not covered in this document, computer modeling of the vehicle engine cooler system is recognized as a valid tool to determine cooler system performance and could be utilized to supplement the testing described. However, adequate in-vehicle testing should be performed to validate the model before it is used for the purposes outlined.

The procedure makes references to test cycles that are prescribed by the United States Environmental Protection Agency (US EPA) and are contained in the Code of Federal Regulations. The existence of other international test cycles, which can be used for validation testing, is acknowledged.

Product Details

Published:

09/01/2011

File Size:

1 file , 2.3 MB

Description

This document has been declared “Stablized” by the SAE IC Powertrain Steering Committee and will not longer be subjected to periodic reviews for currency. Users are responsible for verifying references and continued suitability of technical requirements. Newer technology may exist.

The methods presented in this SAE Recommended Practice apply to the controlled testing of low-temperature charge, air-cooled, heavy-duty diesel engines. this document encompasses the following main sections: a.) definitions of pertinent parameters; b.) Vehicle testing to determine typical values for these parameters; c.) Description of the setup and operation of the test cell system; and d.) Validation testing of the test cell system.

While not covered in this document, computer modeling of the vehicle engine cooler system is recognized as a valid tool to determine cooler system performance and could be utilized to supplement the testing described. However, adequate in-vehicle testing should be performed to validate the model before it is used for the purposes outlined.

The procedure makes references to test cycles that are prescribed by the United States Environmental Protection Agency (US EPA) and are contained in the Code of Federal Regulations. The existence of other international test cycles, which can be used for validation testing, is acknowledged.

Product Details

Published:

09/06/2011

File Size:

1 file , 2.3 MB